|
5- 15 TCP/IP Network Settings (Windows, Macintosh, UNIX)トップChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexTOPContentsChapter 2Using Various MediaChapter 1Basic UseConfiguring TCP/IP Protocol Settings“Remote UI”, the software application built into the networkinterface of this printer, allows you to use a Web browser onyour computer to monitor the status of the printer andperform the network information settings for the printer. Setting the Protocol with Web Browser(Remote UI)The procedure below describes how to use Remote UI toperform the network information settings.Importantz You can use Netscape Navigator/Communicator 6.0 orlater, or Internet Explorer 5.01 or later for the webbrowser. The Macintosh Safari web browser is notsupported.z You cannot connect to the printer via a proxy server. Inan environment that uses a proxy server, add theprinter IP address to Exceptions (addresses that donot use a proxy) in the web browser proxy serversettings. (These settings vary depending on thenetwork environment.)z Configure the web browser to enable JavaScript andCookies.z If multiple Remote UIs are run at the same time, thelast setting made will be used. It is recommended thatonly one Remote UI be started at a time.Notez When Remote UI is started using the printer name,make sure that the DNS settings in the DNSenvironment and on the network board have been setup correctly.1 Start the Web Browser and enter thefollowing URL in the Location or Addressbox, then press the Enter key.http:// /Sample: http://XXX.XXX.XXX.XXX/
|
