Canon imagePROGRAF W8400 User Manual

Also see for imagePROGRAF W8400: Brochure & specs Guide Brochure & specs Driver guide Brochure & specs

Contents

Canon imagePROGRAF W8400 User Manual Manual pdf 272 page image

4- 27 Replacing the Cutter BladeTOPChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexContentsChapter 2Using Various MediaChapter 1Basic UseReplacing the Cutter BladeFollow the procedure below to replace the cutter bladewhen it no longer cuts cleanly.z Replacing Standard Cutter Blades (Flat Cutters)(→ P.4-27)z Replacing Optional Cutter Blades (RoundCutters) (→ P.4-30)Replacing Standard Cutter Blades(Flat Cutters)Change the cutting position of a blade when the blade nolonger cuts cleanly. The cutting position can be changedtwice for each blade. Once the cutting position adjustmentdial is set to 3, replace the blade with a new one.z Cutter Blade CT-021 If the printer power is off, press the Powerbutton to switch the printer on.After a few moments, Online appears in the display.2 Press the Online button to display MAINMENU.3 Press [] or [] to display System Setupthen press [].4 Press [] or [] to select Change Cutter,then press [].MAIN MENUSystem Setup ↓System SetupChange Cutter ↓DataInformation PowerOfflineMenuMessageOnlineCleaning(3 sec.)Stop/Eject(1 sec.)MAIN MENUHead CleaningOnlineCleaning(3 sec.)Stop/Eject(1 sec.)