5- 5 TCP/IP Network Settings (Windows, Macintosh, UNIX)トップChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexTOPContentsChapter 2Using Various MediaChapter 1Basic UseTCP/IP Network Settings (Windows, Macintosh, UNIX)This chapter describes the configuration procedures forconnecting the printer to a TCP/IP network.Procedures Required for a TCP/IPNetworkThe following is a summary of the procedures required toset the printer for use on a TCP/IP network.The following work should be performed by the networksystem administrator.Connecting the LAN Cable1 Use a LAN cable to connect the printer LANport to a port on the hub.1 Installing the network interface board → Quick StartGuideFirst, install the optional network interface board.2 Connecting the LAN Cable → P.5-5Connect the printer LAN board to the HUB using anetwork cable.3 Setting the Printer IP Address → P.5-7Set the printer IP address so that the printer cancommunicate with the computer you are using.Settings can be made using one of the following.• GARO Device Setup Utility (Canon softwareapplication provided with the printer.)• ARP/PING command• Printer Operation Panel4 Installing the Printer Driver → Quick StartGuideYou can use the Canon IMAGEPROGRAF printerdriver for Windows or the Canon IMAGEPROGRAFprinter driver for Macintosh (OS X). Install the printerdriver by following the procedure in the quick startguide. There is no printer driver for UNIX.5 Configuring TCP/IP Protocol Settings → P.5-15Configure the TCP/IP protocol settings as required.You can use a Web Browser to configure thesesettings from your computer.a
