6- 22 When You Cannot PrintTOPChapter 3Printing by ObjectiveChapter 4MaintenanceChapter 5Using the Printerin a NetworkEnvironmentChapter 6TroubleshootingChapter 7Operating theFunction MenuIndexContentsChapter 2Using Various MediaChapter 1Basic UseCause 5: The Media Type in the media source selectionis not selected.Solution 1: Use the printer operation panel to select thecorrect setting for the media type. (→ P.2-34)Solution 2: If the Media Type selection is incorrect, cancelthe print job in the computer side, open theprinter driver and select the correct setting forthe “print media loaded”. (→ P.1-44, P.2-4)Cause 6: No ink.Solution 1: When the ink tank replacement messageappears, replace the ink tank for the indicatedcolor. (→ P.4-2)Ink initialization operation starts unexpectedly.Cause 1: When the printer was switched off previously,this force cancelled a cleaning operation.Solution 1: Wait for the ink initialization operation to finish.Ink filling may require up to 10 minutes tocomplete.Printing Halts During Print JobError message is displayed.Cause 1: An error message is displayed during printing.Solution 1: Read the message displayed in the GAROStatus Monitor or GARO Printmonitor, andcorrect the problem indicated by the errormessage. (→ P.6-2)Cause 2: Roll media ran out during the print job and thetape on the trailing edge of the media sheet ispreventing the rest of the sheet from feeding.Solution 1: Follow the procedure for removing a media jam.Remove the used roll and replace it with a newone. (→ P.6-37)
