804.5.11. LLDP ConfigurationOn the Basic Switch Configuration Menu, pressing "L" opens the LLDP Configura-tion screen, as shown in Fig. 4-31. On this screen, you can configure the LLDP set-tings.PN28248 Local Management SystemBasic Switch Configuration -> LLDP ConfigurationLLDP Status : DisabledPort Admin Status Port Desc Sys Name Sys Desc Sys Cap Mgmt Addr---- ------------ --------- -------- -------- -------- ---------1 Both Disabled Disabled Disabled Disabled Disabled2 Both Disabled Disabled Disabled Disabled Disabled3 Both Disabled Disabled Disabled Disabled Disabled4 Both Disabled Disabled Disabled Disabled Disabled5 Both Disabled Disabled Disabled Disabled Disabled6 Both Disabled Disabled Disabled Disabled Disabled7 Both Disabled Disabled Disabled Disabled Disabled8 Both Disabled Disabled Disabled Disabled Disabled9 Both Disabled Disabled Disabled Disabled Disabled10 Both Disabled Disabled Disabled Disabled Disabled-------------------------------- -----------------------------------[N]ext Page [S]et LLDP Status Enable/Disable TL[V][P]revious Page [L]LDP Port Admin Status N[e]ighbor Table[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-31 LLDP ConfigurationScreen DescriptionLLDP Status Displays the LLDP settings.Enabled Enables the LLDP.Disabled Disables the LLDP.(Factory default setting)Port Displays the port number.Admin Status Displays the LLDP status.TX Only Executes only LLDP transmission.RX Only Executes only LLDP receiving.Both Executes LLDP transmission and receiving. (Factory default set-ting)Disabled Does not execute LLDP transmission and receiving.Port Desc Displays whether or not interface information is included in the frame of theLLDP.Enabled Included in the LLDP.Disabled Not included in the LLDP. (Factory default setting)Sys Name Displays whether or not the host name is included in the frame of the LLDP.Enabled Included in the LLDP.Disabled Not included in the LLDP. (Factory default setting)
