1124.6.4.c. Designated Topology InformationOn the Rapid Spanning Tree Configuration Menu, pressing "I" opens the Desig-nated Topology Information screen, as shown in Fig. 4-48. On this screen, you canview the Spanning Tree topology information by port.PN28248 Local Management SystemRapid Spanning Tree Configuration -> Designated Topology InformationPort Trunk Link Desig. Root Desig. Cost Desig. Bridge Desig. Port---- ----- ---- ----------------- ----------- ----------------- -----------1 --- Down 0000 000000000000 0 0000 000000000000 00 002 --- Down 0000 000000000000 0 0000 000000000000 00 003 --- Down 0000 000000000000 0 0000 000000000000 00 004 --- Down 0000 000000000000 0 0000 000000000000 00 005 --- Down 0000 000000000000 0 0000 000000000000 00 006 --- Down 0000 000000000000 0 0000 000000000000 00 007 --- Down 0000 000000000000 0 0000 000000000000 00 008 --- Down 0000 000000000000 0 0000 000000000000 00 009 --- Down 0000 000000000000 0 0000 000000000000 00 0010 --- Down 0000 000000000000 0 0000 000000000000 00 0011 --- Down 0000 000000000000 0 0000 000000000000 00 0012 --- Down 0000 000000000000 0 0000 000000000000 00 00-------------------------------- -----------------------------------[N]ext Page [P]revious Page [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-48 Designated Topology InformationScreen DescriptionPort Displays the port number.Trunk Display the group number of trunk port number.Link Displays the link status.UP The link has been established successfully.DOWN The link has not been established.Desig.Root Displays the route bridge ID.Desig.Cost Displays the cost in transmission.Desig.Bridge Displays the bridge ID of the designated bridge.Desig.Port Displays the port ID of the designated port. (The port ID is a combinationof the port priority value and port number.)Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.Q Return to the parent menu.
