754.5.8.e. Display of MAC Address Table by VLANOn the Forwarding Database Menu, press "V." The command prompt changes to"Enter VLAN ID>." Specifying a port number opens the Display MAC Address byVLAN ID screen as shown in Fig. 4-28. On this screen, you can display the MACaddress table by VLAN.PN28248 Local Management SystemForwarding Database Menu -> Display MAC Address by VLAN IDAge-Out Time: 300 Sec. Selected VLAN ID:1MAC Address Port----------------- ------------------------------------ -----------------------------------[N]ext Page [S]elect VLAN ID[P]revious Page [Q]uit to previous menuSet [A]ge-Out TimeCommand>Enter the character in square brackets to select optionFig. 4-28 Display of MAC Address Table by VLANScreen DescriptionAge-Out Time: Displays the time to store the MAC address table. It is equal to the time afterreceiving the last packet. The factory default setting is 300 seconds (5 minutes).Select VLAN ID: Displays the selected VLAN ID.MAC Address Displays all the entries in the MAC address table.Port Displays the port to which the MAC address has been belongs.Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.A Set the time to store the MAC address.Press "A." The command prompt changes to "Enter Age-Out time>." Enter the age-out timewith a value of 10 to 1000000 (seconds).S Switch the VLAN to be displayed.Press "S." The command prompt changes to "Enter VLAN ID>." Enter a VLAN ID you wish todisplay.Q Return to the parent menu.
