994.6.2.c. Set Port Priority for LACPOn the Trunk Configuration Menu, pressing "o" opens the Set Port Priority screen,as shown in Fig. 4-40. On this screen, you can set the priority value of trunking.PN28248 Local Management SystemTrunk Configuration Menu -> Set Port PrioritySystem Priority : 1System ID : xx:xx:xx:xx:xx:xxPort Priority----- ----------1 12 13 14 15 16 17 18 19 110 1-------------------------------- -----------------------------------[N]ext Page [S]et Port Priority[P]revious Page [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-40 Set Port Priority for LACPScreen DescriptionSystem Priority The system priority is the order of the priority in this Switching Hub required forconstructing trunking on the network using LACP.The smaller number has higher priority. The factory default setting is "1."System ID The System ID is the identifier of this Switching Hub required for constructingtrunking on the network using LACP.The MAC address of this Switching Hub becomes this System ID, and it is not pos-sible to change this ID. Combination of the System Priority value and the SystemID becomes the System ID in LACP.Port The port number of this Switching Hub.Priority The priority order of this Switching Hub in trunking by port. The smaller numberhas higher priority. For all ports, "1" is the factory default setting.Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.S Set the priority value (priority order) by port.Press "S." The command prompt changes to "Enter Port number>." Enter a port number youwish to configure. The command prompt changes to "Enter port priority>." Enter a priority0-255.Q Return to the parent menu.
