1004.6.2.d. LACP Group StatusOn the Trunk Configuration Menu, pressing "G" and specifying a key of the LACPgroup open the LACP Group Status screen, as shown in Fig. 4-41. On this screen,you can confirm the status of the LACP group. (Displaying the status is possibleonly for a key whose mode is Active or Passive.)PN28248 Local Management SystemTrunk Configuration Menu -> LACP StatusSystem Priority : 1System ID : xx:xx:xx:xx:xx:xxKey : 2Aggregator Attached Port List Standby Port List---------- -------------------------------- --------------------------------1 12 2-------------------------------- -----------------------------------[N]ext Page [P]revious Page [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-41 LACP Group StatusScreen DescriptionSystem Priority The system priority is the order of the priority in this Switching Hub required forconstructing trunking on the network using LACP.The smaller number has higher priority. The factory default setting is "1."System ID The System ID is the identifier of this Switching Hub required for constructingtrunking on the network using LACP.The MAC address of this Switching Hub becomes this System ID, and it is not pos-sible to change this ID. Combination of the System Priority value and the SystemID becomes the System ID in LACP.Key Displays the group number of trunking.Aggregator Aggregator is the number of the logical interface of trunking. This is the samenumber as the one of the port whose Port Priority value is the highest in the portsthat are constructing trunking.Attached PortListThis is the number of the physical interface (Port) connected to the logical inter-face (Aggregator). When a trunking group with more than 9 ports is configured,ports with a low Port Priority value are in backup mode and indicated as"(Standby)."Standby port List When a trunking group with more than 9 ports is configured, ports with a lowPort Priority value are in backup mode. The applicable ports are displayed in thiscolumn.
