1024.6.3. Port Monitoring ConfigurationOn the Advanced Switch Configuration Menu, pressing "M" opens the Port Moni-toring Configuration Menu screen, as shown in Fig. 4-42. In this Switching Hub,when analyzing communication using a protocol analyzer, etc., it is possible tomonitor other port's packet that cannot be obtained under normal conditionsbecause of being filtered. On this screen, you can configure the port monitoringsettings.PN28248 Local Management SystemAdvanced Switch Configuration -> Port Monitoring Configuration MenuMonitoring Port Be Monitored Port(s)--------------- -----------------------------------------------------------1 2Direction Status--------- -------------Both Disabled-------------------------------- -----------------------------------[S]et Monitoring PortSet Ports to be [M]onitoredSet Traffic [D]irection[C]hange Mirror Status[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-42 Port Monitoring ConfigurationScreen DescriptionMonitoring Port Displays the destination port number of data for which port monitoring hasbeen executed.Be Monitored Port(s) Displays the port number(s) that are targets of port monitoring.Direction Displays the communication direction of the target packet for port monitor-ing.Tx Monitors the transmit packet.Rx Monitors the receive packet.Both Monitors both of the transmit and receive packets. (Fac-tory default setting)Status Displays the monitoring status.Enabled Port monitoring is enabled.Disabled Port monitoring is disabled. (Factory default setting)
