1584.6.11. Loop Detection Configuration MenuOn the Advanced Switch Configuration Menu, pressing "D" opens the Loop Detec-tion Configuration Menu screen as shown in Fig. 4-74. On this screen, you can con-figure the Loop detection and blocking function settings.For network configuration, refer to Appendix D "Network Configuration Exampleand Notes Using Loop Detection and Blocking Function" in Basic Operation Man-ual.PN28248 Local Management SystemAdvanced Switch Configuration -> Loop Detection Configuration MenuGlobal Loop Detection Status: EnabledPort Trunk Link State Loop Detect Recovery Recovery Time---- ----- ---- ----------- ------------- ---------- ---------------1 --- Down Forwarding Enabled Enabled 602 --- Down Forwarding Enabled Enabled 603 1 Down Forwarding Enabled Enabled 604 1 Down Forwarding Enabled Enabled 605 2 Down Forwarding Enabled Enabled 606 2 Down Forwarding Enabled Enabled 607 --- Down Forwarding Enabled Enabled 608 --- Down Forwarding Enabled Enabled 609 --- Down Forwarding Enabled Enabled 6010 --- Down Forwarding Enabled Enabled 6011 --- Down Forwarding Enabled Enabled 6012 --- Down Forwarding Enabled Enabled 60-------------------------------- -----------------------------------[N]ext Page Set Port [L]oop Detect Status[P]revious Page Set Port Recovery [S]tatus[E]nable/Disable Loop Detection Set Port Recovery [T]imerLoop History [I]nformation [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-74 Loop Detection Configuration MenuScreen DescriptionGlobal Loop Detec-tion StatusDisplays the status of the Loop detection and blocking function.Enabled The Loop detection and blocking function is enabled. (Fac-tory default setting)Disabled The Loop detection and blocking function is disabled.Port Displays the port number.Trunk Displays the link aggregation group ID.Link Displays the link-up status.Up Linking up.Down Linking down.State Displays the operation of the Loop detection and blocking function.Forwarding Sending packets normally.Loop Detect Detecting a loop and blocking a port.Loop Detect Displays the status of the Loop detection and blocking function for eachport.Enabled The Loop detection and blocking function is enabled.(Factory default setting: Ports 1 to 24)Disabled The Loop detection and blocking function is disabled.(Factory default setting: Ports 25 to 26)
