434.5.3.b. SNMP Trap Receiver ConfigurationOn the SNMP Configuration Menu, pressing "T" opens the SNMP Trap ReceiverConfiguration Menu screen, as shown in Fig. 4-12. On this screen, you can config-ure the SNMP Trap settings.PN28248 Local Management SystemSNMP Configuration -> SNMP Trap Receiver Configuration MenuTrap Receiver List:No. Status Type IP Address Community---- -------- ----- --------------- ----------------------------1 Disabled v1 0.0.0.02 Disabled v1 0.0.0.03 Disabled v1 0.0.0.04 Disabled v1 0.0.0.05 Disabled v1 0.0.0.06 Disabled v1 0.0.0.07 Disabled v1 0.0.0.08 Disabled v1 0.0.0.09 Disabled v1 0.0.0.010 Disabled v1 0.0.0.0-------------------------------- -----------------------------------Set Receiver [S]tatus Set Receiver [I]P In[d]ividual Trap ConfigSet Trap [T]ype Set Receiver [C]ommunity [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-12 SNMP Trap Receiver ConfigurationScreen DescriptionTrap Receiver List: Displays the IP addresses and the community names for the current trapreceivers.No. Displays the entry number for the trap receiver.Status Displays the trap sending setting.Enabled Sends traps.Disabled Does not send traps.Type Displays the type of traps.V1 Sends traps of SNMP v1.V2 Sends traps of SNMP v2.IP Address Displays the IP address of the trap receiver.Community Displays the current community name, set for sendingtraps.
