634.5.7.c. Syslog Transmission ConfigurationOn the System Security Configuration Menu, pressing "G" opens the Syslog Trans-mission Configuration Page screen, as shown in Fig. 4-20. On this screen, you canconfigure the settings of the Syslog server to which a system log is sent.PN28248 Local Management SystemSystem Security Configuration -> Syslog Transmission Configuration MenuSyslog Server List:No. Status IP Address Facility Include SysName/IP---- ----------- --------------- ---------- ------------------1 Disabled 0.0.0.0 Facility02 Disabled 0.0.0.0 Facility0-------------------------------- -----------------------------------Set Server [S]tatus Set Server [I]P [Q]uit to previous menuSet Server [F]acility Set S[y]sName/IP Include [C]lear Server InformationCommand>Enter the character in square brackets to select optionFig. 4-20 Syslog Transmission ConfigurationScreen DescriptionStatus Displays the status of each entry.Enabled Setting of the entry is enabled.Disabled Setting of the entry is disabled.IP Address Displays the IP address of the Syslog server.Facility Displays the value of Facility.Include Sys-Name/IPDisplays information to be added.SysName Adds the SysName of this Switching Hub to the system log to betransmitted.IP address Adds the IP address of this Switching Hub to the system log tobe transmitted.Available commands are listed below.S Set the status of Syslog Transmission.1. Press "S." The command prompt changes to "Enter manager entry number>." Enter a num-ber you wish to set.2. Then, the command prompt changes to "Enable or Disable Server (E/D)>." Enter "E" toenable the server. Enter "D" to disable it.
