654.5.7.d. SSH Server ConfigurationOn the System Security Configuration Menu, pressing "H" opens the SSH ServerConfiguration screen, as shown in Fig. 4-21. On this screen, you can configure theSSH server settings.This Switching Hub only supports SSHv2. Use a client that supports SSHv2 andconnect to it.PN28248 Local Management SystemBasic Switch Configuration -> SSH Server ConfigurationSSH UI Idle Timeout: 5 Min.SSH Auth. Idle Timeout: 120 Sec.SSH Auth. Retries Time: 5SSH Server: DisabledSSH Server key: Key exists.-------------------------------- -----------------------------------[G]enerate SSH Server key Enable/Disable SS[H] ServerSet SSH UI Time [O]ut Set SSH [A]uthentication Time OutSet SSH Authentication [R]etries Time [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-21 SSH Server ConfigurationScreen DescriptionSSH UI Idle Timeout: Displays the idle timeout settings (in minutes) for terminating a SSH-connected session if no input is made.The factory default setting is 5 minutes.SSH Auth. Idle Timeout: Displays the time to wait for a response to SSH authentication.The factory default setting is 120 seconds.SSH Auth. Retries Time: Displays the number of times of retransmission of SSH authentication.The factory default setting is 5.SSH Server: Displays the SSH access settings."Disabled" is the factory default setting.Enabled(SSH) Access is enabled.Disabled Access is disabled.SSH Server key: Displays the SSH server key status.Key exists. The server key exists.Key does not exist. The server key does not exist.
