Panasonic PN28248 Operation Manual

Also see for PN28248: Operation manual for cli

Contents

Panasonic PN28248 Operation Manual Manual pdf 126 page image

1264.6.8.a. Set Leave Mode MenuOn the IGMP Snooping Configuration Menu, pressing "L" opens the Set LeaveMode Menu screen as shown in Fig. 4-57. On this screen, you can configure thesettings of operation after receiving a Leave packet.PN28248 Local Management SystemIGMP Snooping Configuration -> Set Leave Mode MenuLeave Delay Time : 5 secPort Mode------ ------------1 Normal2 Normal3 Normal4 Normal5 Normal6 Normal7 Normal8 Normal9 Normal10 Normal-------------------------------- -----------------------------------[N]ext Page [P]revious Page [Q]uit to previous menu[S]et Leave Mode Set Leave Delay [T]imeCommand>Enter the character in square brackets to select optionFig. 4-57 Set Leave Mode MenuScreen DescriptionLeave Delay Time Displays the waiting time after receiving a Leave packet.The factory default setting is 5 seconds.Port Displays the port number.Mode Displays the operation after receiving a Leave packet.Normal Waits for the specified Leave Delay Time and then sendsthe Leave packet from the multicast group member.(Factory default setting)Immediate Sends the Leave packet from the multicast group mem-ber immediately after receiving it.