514.5.5. Port Configuration ExtendOn the Basic Switch Configuration Menu, pressing "E" opens the Port Configura-tion Extend Menu screen, as shown in Fig. 4-15. On this screen, you can displayport status and configure extended port settings.PN28248 Local Management SystemBasic Switch Configuration -> Port Configuration Extend MenuGlobal Jumbo Status: DisabledPort Trunk Type Link Port Name EAP Pkt FW---- ----- ----------- ---- --------------- ------------1 --- 1000T Down Port_1 Disabled2 --- 1000T Down Port_2 Disabled3 --- 1000T Down Port_3 Disabled4 --- 1000T Down Port_4 Disabled5 --- 1000T Down Port_5 Disabled6 --- 1000T Down Port_6 Disabled7 --- 1000T Down Port_7 Disabled8 --- 1000T Down Port_8 Disabled9 --- 1000T Down Port_9 Disabled10 --- 1000T Down Port_10 Disabled11 --- 1000T Down Port_11 Disabled12 --- 1000T Down Port_12 Disabled-------------------------------- -----------------------------------[N]ext Page Set [J]umbo Status[P]revious Page Set [E]AP Packet ForwardingSet Port N[a]me [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-15 Port Configuration Extend MenuScreen DescriptionGlobal JumboStatusDisplays the jumbo frame settings. "Disabled" is the factory default setting.Enabled The jumbo frame is enabled.Disabled The jumbo frame is disabled.Port Displays the port number.Trunk Displays the group number for a trunked port.Type Displays the port type.1000T The port type is 10/100/1000BASE-T.1000X The port type is SFP extension port.Link Displays the current link status.Up A link has been established successfully.Down A link has not been established.Port Name Displays the port name.EAP Pkt FW Displays the EAP Packet Forwarding function settings. For all ports, "Disabled" isthe factory default setting. Set this item to "Enabled" to send EAP frames used inIEEE802.1X authentication or "Disabled" to discard them.Enabled The EAP Packet Forwarding function is enabled.Disabled The EAP Packet Forwarding function is disabled.
