81Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.S Enable/disable the LLDP.Press "S." The command prompt changes to "Enable or Disable (E/D)>."Press "E" to enable the LLDP. Press "D" to disable it.L Set the LLDP status.1. Press "L." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Set Admin Status for port # (1-4)>." Press "1"for TX Only, "2" for RX Only, "3" for Both, or "4" to disable it.V Set information to be included in the LLDP frame sent from this Switching Hub.1. Press "V." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enter transmit TLV." Press "0" for none, "1" forPort Description, "2" for System Name, "3" for System Description, "4" for System Capabil-ity, or "5" for Management IP respectively by specifying the range.E Display the Neighbor Table.Press "E" to move to the Neighbor Table. For configuration details, refer to the next section(4.5.11.a).Q Return to the parent menu.Sys Desc Displays whether or not system overview information is included in the frame ofthe LLDP.Enabled Included in the LLDP.Disabled Not included in the LLDP. (Factory default setting)Sys Cap Displays whether or not system capability information is included in the frame ofthe LLDP.Enabled Included in the LLDP.Disabled Not included in the LLDP. (Factory default setting)Mgmt Addr Displays whether or not the system IP address is included in the frame of theLLDP.Enabled Included in the LLDP.Disabled Not included in the LLDP. (Factory default setting)
