674.5.7.e. LED Base Mode ConfigurationOn the System Security Configuration Menu, pressing "B" opens the LED BaseMode Configuration screen, as shown in Fig. 4-22. On this screen, you can config-ure the LED base mode settings.PN28248 Local Management SystemSystem Security Configuration -> LED Base Mode ConfigurationLED Base Mode: StatusNote: Save Configuration to Flash will be executed when LED Base Mode changed.-------------------------------- -----------------------------------Set LED [B]ase Mode[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-22 LED Base Mode ConfigurationScreen DescriptionLED basemode Displays the current LED base mode.For all ports, the factory default setting is set to the Status mode (Status).Status Operating in the Status mode.Eco Operating in the ECO mode.Available commands are listed below.B Change the current LED base mode.Press "B." The command prompt changes to "Select LED Base Mode (S/E)>." Press "S" tochange the LED base mode to the Status mode. Press "E" to change to the ECO mode.Q Return to the parent menu.Note: When you change the LED base mode, all configuration information will besaved into the internal memory.
