1314.6.9. Power Over Ethernet ConfigurationOn the Advanced Switch Configuration Menu, pressing "P" opens the Power OverEthernet Configuration Menu screen as shown in Fig. 4-60. On this screen, you canconfigure IEEE 802.3at compatible power supply settings.PN28248 Local Management SystemAdvanced Switch Configuration -> Power Over Ethernet Configuration MenuPoE [P]ort ConfigurationPoE [G]lobal ConfigurationPoE [S]chedule Configuration[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-60 PoE ConfigurationAvailable commands are listed below.P Configure PoE for each port.Press "P" to move to the "PoE Port Configuration Menu" screen. Refer to 4.6.9.a.G Configure the PoE settings.Press "G" to move to the "PoE Global Configuration Menu" screen. Refer to 4.6.9.b.S Configure the PoE scheduler settings.Press "S" to move to the “PoE Schedule Configuration Menu” screen. Refer to 4.6.9.c.Q Return to the parent menu.Note: This Switching Hub can supply power up to 185 W in total to terminal devicesconforming to IEEE802.3af or IEEE802.3at. For each port, it can supply up to15.4 W for a IEEE802.3af compatible device and up to 30.0 W for aIEEE802.3at compatible device, however, the total of power required for ter-minal devices to be connected should not exceed 185 W. Otherwise, "Over-load" is displayed in Status in 4.6.9.a, and the power cannot be suppliednormally.
