1504.6.10. Ring Redundant Protocol ConfigurationOn the Advanced Switch Configuration Menu, pressing "R" opens the Ring Redun-dant Protocol Configuration screen as shown in Fig. 4-70. On this screen, you canconfigure the Ring Redundant Protocol (RRP) settings.PN28248 Local Management SystemAdvanced Switch Configuration -> Ring Redundant Protocol ConfigurationRRP Status : Disabled Total Domain Number : 0Domain Name Ctrl VLAN Data VLAN(s) Ring Status Node Type------------------------- ----------- ------------ ----------- ----------------------------------------- -----------------------------------Set RRP [S]tatus [M]odify RRP Domain[C]reate RRP Domain [D]elete RRP DomainS[h]ow RRP Domain information [Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-70 Ring Redundant Protocol Configuration MenuScreen DescriptionRRP Status Displays the Ring Redundant Protocol function status.Enabled The Ring Redundant Protocol function is enabled.Disabled The Ring Redundant Protocol function is disabled. (Factorydefault setting)DomainNameDisplays the domain name.Total DomainNumberDisplays the number of registered domains.(Up to 1 groups can be registered.)Ctrl VLAN Displays the control VLAN ID.Data VLAN(s) Displays the data VLAN ID.Ring Status Displays the ring status.IDLE The Ring Redundant Protocol function is disabled.Complete The ring topology has been correctly established.This status is displayed for the Master nodes only.Failed The ring topology has not been established.This status is displayed for the Master nodes only.Link-Up The ring topology has been correctly established.This status is displayed for the Transit nodes only.Link-Down The ring topology has not been established.This status is displayed for the Transit nodes only.Pre-Forwarding The ring topology is being established.This status is displayed for the Transit nodes only.
