384.5.2. System IP Address ConfigurationOn the Basic Switch Configuration Menu, pressing "I" opens the System IP Config-uration Menu screen, as shown in Fig. 4-9. On this screen, you can set IP-address-related settings for this Switching Hub.PN28248 Local Management SystemBasic Switch Configuration -> System IP Configuration MenuMAC Address: xx:xx:xx:xx:xx:xxIP Address: 0.0.0.0Subnet Mask: 0.0.0.0Default Gateway: 0.0.0.0DHCP Mode: Disabled-------------------------------- -----------------------------------Set [I]P AddressSet Subnet [M]askSet Default [G]atewaySet IP P[a]rameterSet [D]HCP StatusSet DHCP [R]enew[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-9 System IP Address ConfigurationScreen DescriptionMAC Address Displays the MAC address of this Switching Hub. This value is uniquely assigned toeach device and cannot be changed.IP Address Displays the current IP address. "0.0.0.0" is the factory default setting.Subnet Mask Displays the current subnet mask. "0.0.0.0" is the factory default setting.Default Gate-wayDisplays the current IP address of the router, set as a default gateway. "0.0.0.0" isthe factory default setting.DHCP Mode Displays the DHCP mode. If enabled, the Switching Hub requests an IP address tothe DHCP server. "Disabled" is the factory default setting.Enabled Requests an IP address to the DHCP server when starting up.Disabled Does not request an IP address to the DHCP server when startingup.DHCP Renew Renews an IP address from the DHCP server.
