Panasonic PN28248 Operation Manual

Also see for PN28248: Operation manual for cli

Contents

Panasonic PN28248 Operation Manual Manual pdf 113 page image

1134.6.5. Quality of Service ConfigurationOn the Advanced Switch Configuration Menu, pressing "C" opens the Quality ofService Configuration Menu screen, as shown in Fig. 4-49. On this screen, you canconfigure the settings of QoS (Quality of Service) of the Switching Hub.PN28248 Local Management SystemAdvanced Switch Configuration Menu -> Quality of Service Configuration Menu[T]raffic Class Configuration[E]gress Rate Limiting[D]iffserv Configuration[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-49 QoS ConfigurationAvailable commands are listed below.T Move to the Traffic Class configuration screen.Press "T." The screen changes to "Traffic Class Configuration Menu." For the configurationcontents, refer to the next section (4.6.5.a).E Move to the bandwidth control configuration screen.Press "E." The screen changes to "Egress Rate Limiting." For the configuration contents, referto the next section (4.6.5.c).D Move to the DiffServ configuration screen.Press "D." The screen changes to "Diffserv Configuration Menu." For the configuration con-tents, refer to the next section (4.6.5.d).Q Return to the parent menu.