734.5.8.c. Display of MAC Address Table by PortOn the Forwarding Database Information Menu, press "P." The command promptchanges to "Enter Port Number>." Specifying a port number opens the DisplayMAC Address by Port screen as shown in Fig. 4-26. On this screen, you can displaythe MAC address table by port.PN28248 Local Management SystemForwarding Database Menu -> Display MAC Address by PortAge-Out Time: 300 Sec. Selected Port: 1MAC Address Port----------------- ------------------------------------ -----------------------------------[N]ext Page [S]elect Port No[P]revious Page [Q]uit to previous menuSet [A]ge-Out TimeCommand>Enter the character in square brackets to select optionFig. 4-26 Display of MAC Address Table by PortScreen DescriptionAge-Out Time: Displays the time to store the MAC address table. It is equal to the time afterreceiving the last packet. The factory default setting is 300 seconds (5 minutes).Select Port: Displays the selected port number.MAC Address Displays all the entries in the MAC address table.Port Displays the port to which the MAC address belong.Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.A Set the time to store the MAC address.Press "A." The command prompt changes to "Enter Age-Out time>." Enter the age-out timewith a value of 10 to 1000000 (seconds).S Switch the port to be displayed.Press "S." The command prompt changes to "Enter Port Number>." Enter a port number youwish to display.Q Return to the parent menu.
