1784.8.6. System LogOn the Switch Tools Configuration Menu, pressing "L" opens the System Log Menuscreen as shown in Fig. 4-87. This screen displays logs of events caused to theSwitching Hub. By viewing events, you can check activities related to the SwitchingHub, which is useful information for network management.PN28248 Local Management SystemSwitch Tools Configuration -> System Log MenuEntry Time(YYYY/MM/DD HH:MM:SS) Event----- ------------------------- -------------------------------------------1 0000/00/00 00:00:00 Reboot: Factory Default Except IP2 0000/00/00 00:00:00 Login from console3 0000/00/00 00:00:00 (Bridge) Topology Change-------------------------------- -----------------------------------[N]ext Page[P]revious Page[C]lear System Log[S]elect Entry Log number[I]ndividual System Log config[Q]uit to previous menuCommand>Enter the character in square brackets to select optionFig. 4-87 System LogEach event displayed on this screen links to an SNMP trap. Events for which a trapis set to be sent are displayed. The relationships with traps are shown below.Screen DescriptionEntry Displays the event number.Time Displays the time when the event occurred, or the time accumulated after boot if theclock is not set.Event Displays the description of the event caused to the Switching Hub.Note: The event can save maximum of 1024, remove from the date old event.System Log DescriptionLogin from console Indicates a login from the console.Login failed from console Indicates a login authentication failure from the console.Login from telnet xxx.xxx.xxx.xxx>Indicates a login from the host with IP address xxx.xxx.xxx.xxx via Tel-net.Login from SSH xxx.xxx.xxx.xxx>Indicates a login from the host with IP address xxx.xxx.xxx.xxx via SSH.
