52Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.A Assign a name to each port.1. Press "A." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enter port name string>." Enter a name in 15characters or less.As the change is applied, the display on the upper screen is updated automatically.J Enable/disable the jumbo frame.Press "J". The command prompt changes to "Enable or Disable jumbo status (E/D)>." Press"E" to enable the jumbo frame. Press "D" to disable it.As the change is applied, the display on the upper screen is updated automatically.E Enable/disable the EAP Packet Forwarding function.1. Press "E." The command prompt changes to "Enter port number>." Enter a port numberyou wish to configure. (To configure all ports at once, enter "0" as the port number.)2. Then, the command prompt changes to "Enable or Disable EAP forward status for port #(E/D)>." Press "E" to enable the function. Press "D" to disable it.As the change is applied, the display on the upper screen is updated automatically.Q Return to the parent menu.Note: The screen displays the port status; however, the status is not automaticallyupdated. To display the latest status, press any key.
