50Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.A Enable/disable a port.1. Press "A." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enable or Disable port # (E/D)>." Press "E" toenable the port. Press "D" to disable it.As the change is applied, the display on the upper screen is updated automatically.M Configure the speed and full-duplex/half-duplex settings for each port.1. Press "M." The command prompt changes to "Enter port number>." Enter a port numberyou wish to configure. (To configure all ports at once, enter "0" as the port number.)2. Then, the command prompt changes to "Enter mode for port # (A/N)>." Press "A" toenable the auto negotiation mode. Press "N" to disable it.3. If "N" is selected, the command prompt changes to "Enter speed for port #(10/100)>."Select a desired communication speed.4. Upon setting, the command prompt changes to "Enter duplex for port #(F/H)>." Select"F" for full-duplex or "H" for half-duplex.As the change is applied, the display on the upper screen is updated automatically.Mode: A: Enable the auto negotiation mode.N: Disable the auto negotiation mode.(Fixing the speed at 1000BASE-T is not supported)Speed: 10: Set at 10 Mbps.100: Set at 100 Mbps.Duplex: F: Set at full-duplex.H: Set at half-duplex.F Enable/disable the flow control.1. Press "F." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enable or Disable flow control for port # (E/D)>." Press "E" to enable the function. Press "D" to disable it.As the change is applied, the display on the upper screen is updated automatically.S Enable/disable the Auto MDI/MDI-X function.1. Press "S." The command prompt changes to "Enter port number >." Enter a port numberyou wish to configure in the range of 1 to 26. (To configure all ports at once, enter "0" asthe port number.)2. Then, the command prompt changes to "Enable or Disable Auto-MDI for port # (E/D)>."Press "E" to enable the function. Press "D" to disable it.As the change is applied, the display on the upper screen is updated automatically.Q Return to the parent menu.Note: The screen displays the port status; however, the status is not automaticallyupdated. To display the latest status, press any key.
