44Available commands are listed below.S Enable/disable the trap receiver.1. Press "S." The command prompt changes to "Enter manager entry number>." Enterthe entry number for the trap receiver you wish to configure.2. Then, the command prompt changes to "Enable or Disable Trap Receiver (E/D)>."Press "E" to enable the trap receiver. Press "D" to disable it.I Set the IP address for the trap receiver.1. Press "I." The command prompt changes to "Enter manager entry number>." Enterthe entry number for the trap receiver you wish to configure.2. Then, the command prompt changes to "Enter IP address for trap receiver>." Enterthe IP address.D Set trap sending when the link status is changed.Press "D." The screen changes to the Enable/Disable Individual Trap Menu.For detailed configuration, refer to the next section (4.5.3.c).T Set the type of traps.1. Press "T." The command prompt changes to "Enter manager entry number>." Enterthe entry number for the trap receiver you wish to configure.2. Then, the command prompt changes to "Enter the selection>." Press "1" for SNMPv1. Press "2" for SNMP v2.C Set the community name for the trap receiver.1. Press "C." The command prompt changes to "Enter manager entry number>." Enterthe entry number for the trap receiver you wish to configure.2. Then, the command prompt changes to "Enter community name for trapreceiver>." Enter the community name.Q Return to the parent menu.
