42Available commands are listed below.S Set the SNMP manager status.1. Press "S." The command prompt changes to "Enter manager entry number>." Enter theentry number for the SNMP manager you wish to configure.2. Then, the command prompt changes to "Enable or Disable SNMP manger (E/D)>." Press"E" to enable the SNMP manager. Press "D" to disable it.I Set the IP address for an SNMP manager.1. Press "I." The command prompt changes to "Enter manager entry number>." Enter theentry number for the SNMP manager you wish to configure.2. Then, the command prompt changes to "Enter IP address for manager>." Enter the IPaddress.R Set the access privileges for an SNMP manager.1. Press "R." The command prompt changes to "Enter manager entry number>." Enter theentry number for the SNMP manager you wish to configure.2. Then, the command prompt changes to "Enter the selection>." Press "1" for read-only per-mission. Press "2" for read-and-write.C Set the community name for an SNMP manager.1. Press "C." The command prompt changes to "Enter manager entry number>." Enter theentry number for the SNMP manager you wish to configure.2. Then, the command prompt changes to "Enter community name for manager>." Enter thecommunity name.Q Return to the parent menu.
