98Available commands are listed below.T Set System Priority value of this Switching Hub in LACP.Press "T." The command prompt changes to "Enter system priority for LACP >."A Configure new trunking settings.Press "A." The command prompt changes to "Enter trunk group admin key>." Enter a groupnumber you wish to configure. The command prompt changes to "Enter port member forgroup key #>." Enter a port number you wish to do trunking. When entering multiple portnumbers, delimit with comma (,) with no space (example: "1,2,3"), or hyphenate the contin-uous numbers (example: "8-12"). Then, the command prompt changes to "LACP Active,LACP Passive or Manual trunk setting(A/P/M)>." Enter "A" to make operation mode Active,or "P" to make it Passive, or "M" to make it Manual, respectively.R Remove trunking settings.Press "R." The command prompt changes to "Enter trunk group admin key>." Enter a groupnumber you wish to delete. The command prompt changes to "Enter port member port forgroup key #>." Enter a port number you wish to do rdelete. When entering multiple portnumbers, delimit with comma with no space, or hyphenate the continuous numbers.M Modify the operation mode of trunkingPress "M." The command prompt changes to "Enter trunk group admin key>." Enter a groupnumber you wish to modify. Then, the command prompt changes to "LACP Active, LACPPassive or Manual trunk setting(A/P/M)>." Enter "A" to make operation mode Active, or "P"to make it Passive, or "M" to make it Manual, respectively.O Set System Priority value of this Switching Hub by port in trunking.Press "o" to open the "Set Port Priority" screen. For method of detail setting, refer to the sec-tion (4.6.2.c).G Display a status of LACP group.Press "G." The command prompt changes to "Enter trunk group number >." Enter a key ofgroup you wish to display. (Only the group of which mode is Active or Passive can beentered.) Then, screen changes to "LACP Status." For details, refer to the section (4.6.2.c).Q Return to the parent menu.Note: In this Switching Hub, it is possible to set members of up to 26 ports to onegroup, but it is up to 8 ports that execute trunking operation. Members afterthe 9th port in that group get into backup mode. When a failure occurred inlink of 1-8 port, one of them becomes a member that constructs trunk onbehalf of that port. In this case, priority order to become a member is deter-mined by Port Priority that is set in next section (4.6.2.b), and, when Priorityvalue is the same to all, trunk is constructed by a member starting from thesmallest port number in order.
