177Available commands are listed below.I Set the IP address of the target of the ping.Press "I." The command prompt changes to "Enter new Target IP Address >." Enter the IPaddress.N Set the number of times of ping.Press "N." The command prompt changes to "Enter new Request Times >." Enter the num-ber of times between 1 and 10.T Set the time before timeout occurs.Press "T." The command prompt changes to "Enter new Timeout Value >." Set the timebetween 1 to 5 seconds.E Execute the ping command or clear the display.Press "E." The command prompt changes to "Execute Ping or Clean before Ping Data (E/C)>." Press "E" to execute ping. Press "C" to only clear the display.S Cancel the ping command.Press "S" or "Ctrl+C" during the ping execution to cancel it.Q Return to the parent menu.PN28248 Local Management SystemSwitch Tools Configuration -> Ping ExecutionTarget IP Address: 192.168.1.100Number of Requests: 10Timeout Value: 3 Sec.=============== Result ===============No. 1 6 msNo. 2 5 msNo. 3 6 msNo. 4 6 msNo. 5 5 msNo. 6 7 msWaiting for response...-------------------------------- -----------------------------------Set Target [I]P Address [E]xecute PingSet [N]umber of Requests [S]top PingSet [T]imeout Value [Q]uit to previous menuS or Ctrl-C Stop ping functionFig. 4-86 Display during Ping Execution
