125Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.G Change the IGMP Snooping function status.Press "G." The command prompt changes to "Enable or Disable IGMP snooping (E/D)>."Press "E" to enable the function. Press "D" to disable it.U Change the Multicast filtering function status.Press "U." The command prompt changes to "Enable or Disable Multicast Filtering (E/D)>."Press "E" to enable the function. Press "D" to disable it.H Set the aging time of multicast group members.Press "S." The command prompt changes to "Enter age out time>." Set the time between130 and 1225 seconds.R Set the aging time of the multicast group's router port.Press "S." The command prompt changes to "Enter age out time>." Set the time between60 and 600 seconds.I Set the Proxy Report waiting time.Press "I." The command prompt changes to "Enter forward interval>." Set the time between0 and 25 seconds.L Move to the Leave mode configuration screen.Press "L" to move to the "Set Leave Mode Menu" screen. (Refer to 4.6.8.a.)V Move to the VLAN filter configuration screen.Press "V" to move to the "Show IGMP Snooping VLAN Filter Table Menu" screen.(Refer to 4.6.8.b.)T Show the router port table.Press "T" to move to the "Show Router Port Table Menu" screen.(Refer to 4.6.8.c.)M Statically set a router port.1. Press "M." The command prompt changes to "Add or Delete static group member(A/D)>." Press "A" to add a router port. Press "D" to delete it.2. Then, enter the target VLAN ID, multicast MAC address, and port number.Q Return to the parent menu.Note: The IGMP Snooping function and the Internet Mansion mode cannot be usedsimultaneously.
