111Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.E Set Edge Status of each port.1. Press "E." The command prompt changes to "Select port number to be changed>." Enterthe port number you wish to configure.2. Then, the command prompt changes to "Set edge port for port # (T/F)>." Press "T" forTrue or "F" for False.T Set P-to-P Status of each port.1. Press "T." The command prompt changes to "Select port number to be changed>." Enterthe port number you wish to configure.2. Then, the command prompt changes to "Set point-to-point for port # (A/T/F)>." Press "T"for True or "F" for False.M Restart the operation of Spanning Tree.1. Press "M." The command prompt changes to "Select port number to be changed>." Enterthe port number you wish to configure.2. Then, the command prompt changes to "Restart the protocol migration process for port# ? (Y/N)>." Press "Y" to restart. Otherwise, press "N."Q Return to the parent menu.Admin/OperEdgeDisplays the setting of the edge port (a port that can be immediately forwarded).Admin: Administration displays the setting status, and Oper: Operation displaysthe actual status.True Can be set to the edge port.False Cannot be set to the edge port.Admin/OperPtoPDisplays point-to-point connection of the Switching Hub. Admin: Administrationdisplays the setting status, and Oper: Operation displays the actual status.Auto Automatically recognizes according to the port status. (OnlyAdmin)True P-to-P connected.False Not P-to-P connected.Migrat Displays the current operation status of Spanning Tree.STP STP is working.RSTP RSTP is working.Init. STP is not working.
