103Available commands are listed below.S Set a destination port (port to which the analyzer, etc. is connected) of the monitored data.Press "S." The command prompt changes to "Enter port number>." Enter the target portnumber.M Configure a port to be monitored.Press "M." The command prompt changes to "Enter port number>." Enter the target portnumber. (Possible to configure multiple ports)When entering multiple port numbers, delimit with comma, or hyphenate the continuousnumbers.D Set the communication direction of the packet to be monitored.Press "D." The command prompt changes to "Select port monitoring direction(R/T/B)>."Enter "R" to monitor the receive packet, "T" to monitor the transmit packet, or "B" to mon-itor both of the receive and transmit packets.C Set the port monitoring status.Press "C." The command prompt changes to "Enter the select(E/D)>." Enter "E" to startport monitoring. Enter "D" to stop it.Q Return to the parent menu.Note: Management packets such as Ping or ARP transmitted from this SwitchingHub cannot be captured.