Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 99 page image

992. Input/output signal settings2-5-5. Setting the level metersLevel meters for the embedded audio signals transferred bythe SDI input can be displayed on the split screens.Left display:Channel 1 of group 1Right display:Channel 2 of group 11 Press the x button to light its indicator, and display theMulti View Display menu.2 Use [F1] to display the Display sub menu.3 Use [F2] to set the level meter display using the LevelMeter item.On The level meters are displayed.Off The level meters are not displayed.2-5-6. Setting the input signal marksThe status of the input signals can be displayed in front of thematerial names displayed on the split screens.“F” mark:This appears when the input signals are frozen.“ ! ” mark:This appears when no signals are input or when signalswith different formats are input. When the “F” mark is displayed, the “!” mark is notdisplayed.1 On the Display sub menu, use [F3] to set the inputsignal status display using the Input Status item.On The input signal status is displayed.Off The input signal status is not displayed.2-5-7. Setting the markersSafety markers can be displayed for the multi view materials.The markers can be displayed when PGM or PVW materialsare to be displayed in half their original size.4Split Sub screens 1 to 45/6/10Split 1 or 2 sub screens1 On the Display sub menu, use [F4] to set the markerdisplay using the Marker item.4:3 The markers are displayed using the 4:3aspect ratio.16:9 The markers are displayed using the 16:9aspect ratio.Off The markers are not displayed.2 Use [F5] to set the size of the markers using the MarkerSize item.2-5-8. High-resolution multi view modeThe image output on a multi view display can be output inhigh resolution to DVI-D output.p These settings can be established when the system modeis set to SD.1 Press the s button to light its indicator, and display theSystem menu.2 Use [F1] to display the Format sub menu.3 Use [F3] to set “On” or “Off” using the Hi Resolutionitem, and press the [F3]. Turning this setting “On” switches the Source item tothe default value if the following output signals in theSource item of the Assign submenu under the Outputmenu are set to “MV”.SDI OUT1 to SDI OUT5, OUT-A1, OUT-A2,OUT-B1, OUT-B2 Turning this setting “On”, while the multi view displaysignal is output to the AUX bus or DISP bus, switchesthe output signal to the black signal (internallygenerated signal).