281. Basic operations1-4. PinP (picture in picture)Another image can be combined with the background image.This unit supports two PinP channels.1-4-1. Selecting the PinP channel andmaterialPress the [PinP1] button (or [PinP2] button) among the AUXbus selector buttons.When the [PinP1] button (or [PinP2] button) is lit, the PinP1menu (or PinP2 menu) is displayed on the built-in display.The state in which the PinP1 materials (or PinP2 materials)are selected is now established for the AUX bus crosspointbuttons.The selected AUX bus crosspoint button lights in amber.(It will light in red if the selected signal is a PGM outputsignal.)AMBER : FILL / GREEN : SOURCEKEY PinP1 PinP2 DSK AUX1 AUX2 AUX3 AUX4 DISP MVAUX BUS DELEGATIONAUXAUX/DISP SOURCESHIFTPGMPVW1-4-2. Transition between PinP materialsWhen a PinP bus material has been selected, the effect to beproduced when images are switched can be executed as aMIX transition. (Bus transition function)p When one material set to the Dot by Dot mode andanother material have been switched, cut switching wherethe images change in an instant is performed.1 Press the t button to light its indicator, and display theTime menu.2 Use [F1] to display the PinP1 BUS Trans sub menu (orPinP2 BUS Trans sub menu).3 Use [F3] and [F4] to set the transition time.4 Use [F5] to set enable or disable for the bus transitionfunction.Enable EnableDisable DisableWhile the transition is underway, the indicator of the transitionsource button lights, and the indicator of the transitiondestination button blinks.When the transition is completed, the indicator of thetransition source button goes off, and the indicator of thetransition destination button lights.When another signal has been selected while a transition isunderway, the processing for the transition will continue fromthe interim point.
