Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 100 page image

1002. Input/output signal settings2-6. Setting the ancillary data andembedded audio dataA function for allowing the V ancillary data and embeddedaudio data of the SDI input signals to pass through can beset.When an HD format is used:The ancillary data starting with line 9 is allowed to passthrough.When an SD format is used:The ancillary data starting with line 12 is allowed topass through.p When 1080/59.94i, 720/59.94p, 1080/50i or 720/50p hasbeen selected as the unit’s system format setting, it is notpossible to allow the ancillary data and embedded audiodata to pass through even if SD format signals (480/59.94ior 576/50i) have been input in the Dot by Dot mode or UpConvert mode. Refer to “2-1-2. Setting the input mode”.1 Press the s button to light its indicator, and display theSystem menu.2 Use [F1] to display the Ancillary sub menu.Setting for the program output signals3 Use [F3] to select “On” or “Off” using the PGM item.On The ancillary data and embedded audio dataof the SDI input materials selected by thePGM bus are allowed to pass through.Off The ancillary data and embedded audio dataare not allowed to pass through.Setting for the preview output signals4 Use [F4] to select “On” or “Off” using the PVW item.On The ancillary data and embedded audio dataof the SDI input materials selected by thePST bus are allowed to pass through.Off The ancillary data and embedded audio dataare not allowed to pass through.Setting for the output signals of the multi view display5 Use [F5] to select “PGM”, “PVW” or “Off” using the MVitem.PGM The ancillary data and embedded audio dataof the SDI input materials selected by thePGM bus are allowed to pass through.PVW The ancillary data and embedded audio dataof the SDI input materials selected by thePST bus are allowed to pass through.Off The ancillary data and embedded audio dataare not allowed to pass through.Setting for the output signals of the AUX buses (AUX1to AUX4)6 Use [F2] to select “On” or “Off” using the AUX item.On The ancillary data and embedded audio dataof the SDI input materials selected by theAUX bus (AUX1 to AUX4) are allowed to passthrough.Off The ancillary data and embedded audio dataare not allowed to pass through.