Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 7 page image

71. Basic operationsSingle SHIFTSingle SHIFT is used to switch the individual material of aPGM/A bus crosspoint button, PST/B bus crosspoint buttonor AUX bus crosspoint button from a front material to a rearmaterial or vice versa.Switching between the front material and rear material isdone using the crosspoint button in which the SHIFT functionis allocated.The SHIFT function can be allocated to button No.1 or No.12.w Allocating the SHIFT function1 Press the x button to light its indicator, and display theXPT menu.2 Use [F1] to display the XPT Setting sub menu.3 Use [F2] to select the button to which the SHIFTfunction is to be allocated using the Shift item.Right Button No.12Left Button No.1Off Function is not allocated.4 Use [F3] to select the operation to be performed whenthe [SHIFT] button is pressed using the Shift-Lock item.Off The rear material is selected only while the[SHIFT] button is pressed.On The front material and rear material areswitched each time the [SHIFT] button ispressed. To use the materials that have been set in the buttonto which the SHIFT function is allocated, either set theSHIFT function off or allocate the SHIFT function toanother button. If the [SHIFT] button for “Single SHIFT” is pressed whenthe rear materials (13 to 24) have been selected using“All SHIFT”, the bus crosspoint buttons concerned will beswitched to the front materials. When the crosspoint buttons are held down, the buttonnumbers and the names of the input materials assignedto the buttons are displayed on the built-in display in theform of a list for as long as the crosspoint buttons remainheld down.1-1-3. Selecting the bus modeSelect the A/B bus system or flip-flop system (PGM/PSTsystem) from the setting menu.1 Press the s button to light its indicator, and display theConfig menu.2 Use [F1] to display the Operate sub menu.3 Use [F2], and select the A/B or PGM/PST (flip-flopsystem) using the Bus Mode item.A/B When the fader lever is at side A, the signalsselected by the A bus are replaced PGMmaterials.When the fader lever is at side B, the signalsselected by the B bus are replaced PGMmaterials.PGM-A/PST-BUsing a flip-flop system, the signals selectedby the A bus are always replaced PGMmaterials, and the signals selected by theB bus are always replaced PST materials.PGM-B/PST-AUsing a flip-flop system, the signals selectedby the B bus are always replaced PGMmaterials, and the signals selected by theA bus are always replaced PST materials.1-1-4. Selecting the transition modeSelect the transition mode using the MIX and WIPE buttons.1 Press the [BKGD] button in the transition area so that itsindicator lights in amber.When the [BKGD] button and [KEY] button are pressedat the same time, both buttons are selected.2 Use the [MIX] and [WIPE] buttons in the transition areato select the background transition mode.The indicator of the selected button lights in amber.