111. Basic operations1-2-4. Setting the wipe start positionWipe start can be set at any desired position.Target patterns:WIPE1: 5WIPE2: 4, 5, 6, 7SQ1: 5SQ2: 4, 5, 6, 7The WIPE pattern is set using the WIPE Position sub menu ofthe Background menu (or Key menu).In the same way, the SQ pattern is set using the SQ Positionsub menu of the Background menu (or Key menu).1 Press the b button (or k button) to light its indicator,and display the Background menu (or Key menu).2 Use [F1] to display the WIPE Position sub menu (or SQPosition sub menu).3 Either operate the positioners or use [F2] and [F3] to setthe wipe start position using the X-Pos item and Y-Positem.This setting is possible only if the target pattern hasbeen selected for the background or key pattern.4 Either operate the fader lever or press the [AUTO]button to check the wipe operation.(When, for instance, –50 has been set for X-Pos and–50 for Y-Pos, the following screen (or key) appearsfrom the bottom left and wipe is performed while thescreen (or key) moves to the screen center.)Inside screen areaOutside screen area5 To copy the start position setting, press [F5] (Copy toKey or Copy to BKGD).The background setting is copied to the key settingwhile the key setting is copied to the background setting.1-2-5. Modifying wipeSetting the 3D (page turning) effectA lighting effect can be added to a wipe pattern.Alternatively, the page turning effect parameter can be set.These effects can be set for background transitions and keytransitions.Target patterns:3D1: 1, 3, 7, 91 Press the b button (or k button) to light its indicator,and display the Background menu (or Key menu).2 Use [F1] to display the 3D Modify sub menu.3 Use [F2] to select whether the lighting effect is to beadded using the Light item.On The lighting effect is added.Off The lighting effect is not added.4 Use [F3] to set the size when images have beenreduced using the Size item.5 Use [F4] to set the radius of the page turning effectusing the Radius item.6 Use [F5] to set the direction of the page turning effectusing the Angle item.
