Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 78 page image

782. Input/output signal settings2-1-6. Setting the up-converterSelect the settings for SDI IN5 to SDI IN8, as well as for theup-converter that is built into the option boards listed below: AV-HS04M1 (SDI Input Board) AV-HS04M2 (Analog Input Board) AV-HS04M6 (Analog Composite Input Board)1 On the Input sub menu, use [F2] to select the input tobe set using the Select item. Refer to “2-1. Input signal settings”.2 Use [F1] to display the Up Converter1 sub menu.3 Use [F2] to select the scaling system using the Scaleitem.Squeeze The image is enlarged both horizontally andvertically to fill the entire screen.Edge Crop The aspect ratio of the image is maintained,the image size is increased in accordancewith the vertical resolution, and black bandsare added at the left and right.Letter Box The aspect ratio of the image is maintained,the image size is increased in accordancewith the horizontal resolution, and the imageis cropped at the top and bottom.Input image SqueezeEdge Crop Letter Box4 Use [F3] to set the image movement detectionsensitivity using the Move Detect item.1 Toward still images 3 Standard 5 Toward moving images5 Use [F4] to set the extent of the edge sharpness for theimages using the Sharp item.1 Not sharp edges 3 Standard 5 Very sharp edges6 Use [F5] to adjust the input image size (100 % to110 %).Fine-tuning of image positionsFine-tuning of image positions is performed when “EdgeCrop” is selected for the scaling method.1 Use [F1] to display the Up Converter2 sub menu.2 Use [F2] to select the image position using the EdgeCrop Pos item.Center The image is positioned at the center, andblack images are added at the left and right.Right The image is positioned at the right, and ablack image is added at the left.Left The image is positioned at the left, and ablack image is added at the right.Setting the gamut limiter1 On the Up Converter2 sub menu, use [F4] to set thecolor range of the input signals using the Limiter item.Off The color range is not restricted.108 The amplitude level of the colors (R, G andB) is restricted to 0 % - 108 %.104 The amplitude level of the colors (R, G andB) is restricted to 0 % - 104 %.100 The amplitude level of the colors (R, G andB) is restricted to 0 % - 100 %.