972. Input/output signal settings2-5-2. Setting the split frame andcharactersSet the frame, character brightness and background of thesplit screens to be displayed on the multi view display.1 Press the x button to light its indicator, and display theMulti View Display menu.2 Use [F1] to display the MV Frame sub menu.3 Use [F2] to set the split frame brightness and split framedisplay using the Frame item.LUM0%,LUM25%,LUM50%,LUM75%,LUM100%Select one of these settings for thebrightness of the split frame (gray scale).Off The split frame is not displayed.4 Use [F3] to set the character brightness and characterdisplay using the Character item.LUM0%,LUM25%,LUM50%,LUM75%,LUM100%Select one of these character (gray scale)brightness settings.Off The characters are not displayed.Neither is the character background shown.5 Use [F4] to set whether the character background(half-tone) is to be displayed using the Label item.On The character background is displayed.Off The character background is not displayed.2-5-3. Setting the tally displaysSet the tally displays to be superimposed onto the split frameof the multi view display.The red tally indicates material consisting of program outputs.The green tally indicates material selected by the preset bus.On the MV Frame sub menu, use [F5] to set the tallydisplays using the Tally item.Red+Green Both the red tally and green tally aredisplayed.Red Only the red tally is displayed.Off No tally displays are shown. The red tally is not displayed during FTB operation whilethe program images have been completely faded out to ablack screen. At this time, the green tally is displayed forimages consisting of program images.However, the red tally is displayed when a setting otherthan “White” or “Black” has been selected for the imageused for fading out. Refer to “1-7. FTB (Fade to Black)”. The red tally and green tally signals are output from thetally output connector on the rear panel. Refer to “4-1. Setting the GPI I/O”.
