411. Basic operations1-8. Internal color signalsThis unit supports two sets of internal color signals.1-8-1. Setting the color backgroundThe color background to be used by the bus can be set.Two methods are available: under one method the Hue (hue),Sat (color saturation) and Lum (luminance) are set, and underthe other the 8 preset colors (white, yellow, cyan, green,magenta, red, blue and black) are called.The Hue, Sat and Lum of the called colors can also beadjusted.Adjusting the colors1 Press the b button to light its indicator, and display theColor Background menu.2 Use [F1] to display the CBGD1 Main sub menu (orCBGD2 Main sub menu).3 Use [F2], [F3] and [F4] to perform the color adjustments(Hue, Sat and Lum).w To call the preset colorUse [F5] to select the preset color using the Load item,and press the [F5]. When [F5] is pressed, what has been set so far iscanceled and replaced with the preset color values. To save the values that were set before calling the presetcolor, refer to “1-10. Memory”.1-8-2. Setting the Wash effectThe gradation effect for color backgrounds can be set.Selecting the Wash effect and setting the colors1 Press the b button to light its indicator, and display theColor Background menu.2 Use [F1] to display the CBGD1 Wash sub menu (orCBGD2 Wash sub menu).3 Use [F2] to set the Wash (gradation) effect using theWash item.On The gradation effect is added.Off The gradation effect is not added.4 Use [F3] to set the color of the Wash (gradation) effectusing the Color item.Dual A dual-color gradation effect is added.(This results in a gradation of two colors,namely, the CBGD1 Main color and theCBGD1 Sub color.)Rainbow The rainbow color gradation effect is added.5 When “Dual” has been selected, use [F1] to display theCBGD1 Sub sub menu (or CBGD2 Sub sub menu), andset the sub color.6 Use [F2], [F3] and [F4] to adjust the colors (Hue, Satand Lum).
