81. Basic operations1-1-5. Manual transitionOperate the fader lever to execute transitions manually.If the fader lever has been operated during auto transition,auto transition will be switched to manual operation as soonas the fader position overtakes the amount of the transitionbeing executed.The bus tally LEDs on the left of the fader lever indicate theprogram bus output status.Top LED only lights PGM/A bus outputTop and bottomLEDs lightDuring the transitionBottom LED onlylightsPST/B bus output1-1-6. Auto transitionp When the [AUTO] button is pressed, the transition isexecuted automatically using the transition time which hasbeen set.p The transition is executed in the remaining time when the[AUTO] button is pressed while the fader lever is beingoperated.p The auto transition time is set using the Time menu.1 Press the t button to light its indicator, and display theTime menu.2 Use [F1] to display the BKGD sub menu.3 Set the transition time.When setting the transition time in frame unitsUse [F4] to set the transition time in frames.When setting the transition time in second unitsUse [F3] to set the time in seconds and [F4] to set itin frames.The display unit is set by selecting Config menu Operate sub menu Time Unit item.Sec The time is displayed as a number ofseconds.Frame The time is displayed as a number of frames.Any time from 0 to 999f can be set. The time which canbe set when seconds are used as the display unit differsdepending on the system format.59.94i: max. 33s09f 59.94p: max. 16s39f50i: max. 39s24f 50p: max. 19s49f24PsF: max. 41s15f 23.98PsF: max. 41s15f1-1-7. Cut transitionWhen the [CUT] button is pressed, the transition is executedinstantly.
