Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 77 page image

772. Input/output signal settings2-1-3. Setting the delay amountThe input signals can be delayed.p The delay can be applied only to the SDI IN7 and SDI IN8input signals.1 On the Input sub menu, use [F2] to select the input tobe set using the Select item. Refer to “2-1. Input signal settings”.2 Use [F1] to display the FS sub menu.3 Use [F4] to set the delay amount using the Delay item.2-1-4. Freezing the input signalsThe input signals can be frozen and used.While signals are frozen, the tally signals of the correspondinginput will not be output.Setting freeze1 On the Input sub menu, use [F2] to select the input tobe set using the Select item. Refer to “2-1. Input signal settings”.2 Use [F1] to display the Freeze sub menu.3 Use [F2] to select the freeze method using the Selectitem.Frame The images are frozen frame by frame.Field The images are frozen field by field.This is used to freeze moving images.With interlace signals, however, diagonallines and moving parts appear jagged.Frame or Field can also be selected while an image isfrozen.4 Press the [F3] to freeze the input image or cancel thefreeze.If the [F3] is pressed while the display is “Off”, the videosignal is frozen, and the display is set to “On”.If the [F3] is pressed while the display is “On”, the videosignal freezing is canceled, and the display is set to“Off”.The “F” mark appears in front of the name of thematerial when the signals set for output of multi viewdisplays are frozen. When the unit is used with the frame synchronizerfunction OFF, the output images may be disturbed whenfreezing is executed, but the frozen images will not beadversely affected. If, when the switcher is used with the frame synchronizerfunction at OFF, “On” is set as the freeze setting, theframe synchronizer function will be automaticallyswitched to ON.2-1-5. Setting the material namesMaterial names can be given to the input signals.These names can be selected from the default settings oruser settings.1 On the Input sub menu, use [F2] to select the input tobe set using the Select item. Refer to “2-1. Input signal settings”.2 Use [F1] to display the Name sub menu.3 Use [F2] to select the type of material names using theType item.Default(defaultsettings)Select the material names from the following:SDI IN1 to SDI IN8, DVI IN, IN-A1, IN-A2,IN-B1 and IN-B2.User(usersettings)The material names are set using up to 7characters.