Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 92 page image

922. Input/output signal settings2-3. Setting the sync signalsThe sync signals to be used by the system can be selected.External sync:For synchronization with an external sync signal(gen-lock).The reference input signal is looped through and output.BB Black burst signal (vertical phase of 0H)BBAdvancedBlack burst signalVertical phase of 90H when the 59.94i or59.94p format is selected;vertical phase of 75H when the 50i or 50pformat is selectedTri-level sync Tri-level sync signal (vertical phase of 0H) This can be selected when the systemformat is 1080/24PsF.Internal For synchronization with an internal referencesignal (INT).The REFOUT signal (black burst signal) isoutput from the two reference connectors. This cannot be selected when the systemformat is 1080/24PsF. When 1080/24PsF is selected as the format, INT(internal synchronization) cannot be selected in theSync item of the Reference sub menu. This unit supports synchronization signals for fieldfrequencies that are same as those of the systemformat.When the unit is set to the 1080/23.98PsF format,however, the unit also supports black burst signalswith 10F-1D (compliant with the SMPTE318Mstandard).1 Press the s button to light its indicator, and display theSystem menu.2 Use [F1] to display the Reference sub menu.3 Use [F2], select the sync signal using the Sync item,and press the [F2] to enter the selection.4 Use [F3] to select the setup level of the black burstsignal in the internal synchronization mode using the BBSetup item.This setting takes effect when the video system is 59.94ior 59.94p.The setup level is fixed at 0 IRE when the system is 50ior 50p.5 The genlock status is displayed in the Gen Lock item.Locked Synchronized with the external sync signal orinternal reference signal.UnLock Not synchronized with the external syncsignal or internal reference signal.2-4. Adjusting the output signalphaseThe phase of the output video signals can be adjusted.1 Press the s button to light its indicator, and display theSystem menu.2 Use [F1] to display the Output Phase sub menu.3 Use [F2], and select “0H” or “1H” using the System item.0H The output video signals are output to thesystem Reference signal with using in-phase.The frame synchronizer function is ON for allinput signals.1H The output video signals are output to thesystem Reference signal with 1H delay.When the frame synchronizer function is ON,the output video signals are output with1 frame + 1H delay.4 Use [F3] to adjust H phase using the H-Phase item.H-Phase can be adjusted within a range of –0.5H to+0.5H. The setting displayed on the menu differs dependingon the system format.5 Use [F4] to adjust V phase using the V-Phase item.V-Phase can be adjusted within a range of –100H to+100H.