Panasonic AV-HS410N Operating Instructions Manual

Also see for AV-HS410N: Brochure & specs Operating instructions

Contents

Panasonic AV-HS410N Operating Instructions Manual Manual pdf 86 page image

862. Input/output signal settings2-1-12. Adjusting the DVI input signalsThese are used to adjust the clock/phase and position of theDVI-D input signal.Select the clock/phase and position of the signals when theDVI input board (AV-HS04M3) has been connected.1 On the Input sub menu, use [F2] to select the input tobe set using the Select item. Refer to “2-1. Input signal settings”.2 Use [F1] to display the DVI Phase sub menu.3 Use [F2] to adjust the clock phase of the analog inputsignals using the Clk Phs item.While viewing the image quality, set the value at whichthe noise level is minimized.4 Use [F3] to adjust the horizontal position using theH-Pos item.5 Use [F4] to adjust the vertical position using the V-Positem.2-1-13. Automatic adjustment of the blacklevel and white level (analog inputsignals)The black level (offset) and white level (gain) of the analoginput signals are adjusted automatically.p Set this when the DVI input board (AV-HS04M3) has beenconnected.Depending on the computer used, there may be somedeviation from the correct levels of the black level or whitelevel.To proceed with automatic adjustment to correct thisdeviation, display the black-and-white signals (BW.bmp) onthe supplied CD-ROM or the full-screen black signals andfull-screen white signals on the computer connected to theDVI input connector, and input these signals as the DVI inputsignals.When using the black-and-white signals, position them so thatthe boundary between black and white comes to the center ofthe monitor screen.When using the full-screen black signals or full-screen whitesignals, display the black or white in an area that covers atleast 80 % of the screen from the screen center.Before making any adjustments, follow the instructions givenin the “Automatic adjustment of the black level” section.Automatic adjustment of the black levelInput the black-and-white signals (BW.bmp) or full-screenblack signals.Use [F5] to select “Black” in the Auto item, and press [F5]to adjust the black level automatically.“Auto Setting” is displayed on the built-in display whileadjustments are being made.Automatic adjustment of the white levelInput the black-and-white signals (BW.bmp) or full-screenwhite signals.Use [F5] to select “White” in the Auto item, and press [F5]to adjust the white level automatically.“Auto Setting” is displayed on the built-in display whileadjustments are being made.Initializing the adjusted valuesUse [F5] to select “Init” in the Auto item, and press [F5] toreturn the adjusted values to their factory settings.“Auto Setting” is displayed on the built-in display whileadjustments are being made.