77Available commands are listed below.P Set the IP address of the SNTP server.Press "P." The command prompt changes to "Enter new IP address>." Enter the IP address ofthe SNTP server.I Set the interval time for SNTP synchronization.Press "I." The command prompt changes to "Enter Interval Time>." Enter the interval of timesynchronization with the SNTP server with a value of 1 to 1440 (minutes).The factory default setting is 1440 minutes (1 day).E Set the application of Daylight Saving (Summer time).Press "E." The command prompt changes to "Enable or Disable Daylight Saving (E/D)>."Enter "E" to apply Daylight Saving. Enter "D" not to apply it.However, in case the set time zone is a zone where Daylight Saving is not applied, this con-figuration is not available.Z Set the time zone.Press "Z" to open a list of time zones. Specify a time zone you wish to set.The factory default setting is "(GMT+09:00) Osaka, Sapporo, Tokyo."Q Return to the parent menu.Note: In case the SNTP server is located outside of the firewall, connection with theSNTP server may not be possible depending on settings by the system admin-istrator.For details, ask your system administrator.If you wish to disable the time synchronization function, set the SNTP server IPto "0.0.0.0."
