54Available commands are listed below.N Display the next page.Press "N" to display the next page.P Display the previous page.Press "P" to display the previous page.S Configure the MNO series power saving mode for each port.1. Press "S." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as the portnumber.)2. Then, the command prompt changes to "Enter Power Saving mode for port (F/H/D)>."Press "F" to enable the mode. Press "D" to disable it. Press "H" to select the MNO seriespower saving mode that prioritizes connection with other devices.As the change is applied, the display on the upper screen is updated automatically.E Configure the EEE settings for each port.1. Press "E." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as the portnumber.)2. Then, the command prompt changes to "Enable, Disable for Energy Efficient Ether-net(EEE 802.3az) (E/D)>." Press "E" to enable the EEE. Press "D" to disable it.Q Return to the parent menu.Mode Displays the communication speed and full-duplex/half-duplex settings.For all ports, "Auto" is the factory default setting.Auto Auto negotiation mode100-FDx(100F) 100 Mbps full-duplex100-HDx(100H) 100 Mbps half-duplex10-FDx(10F) 10 Mbps full-duplex10-HDx(10H) 10 Mbps half-duplexPower-Saving Displays the status of the MNO series power saving mode.For all ports, "Half" is the factory default setting.Half The MNO series power saving mode status is enabled (Half).Full The MNO series power saving mode status is enabled (Full).Disabled The MNO series power saving mode status is disabled.EEE(802.3az) Displays the EEE (Energy Efficient Ethernet) status.For all ports, "Enabled" is the factory default setting.Enabled The EEE is enabled.Disabled The EEE is disabled.
