153Available commands are listed below.N Set the domain name.Press "N." The command prompt changes to "Enter RRP Domain Name>." Enter the name ofthe domain to be configured in 25 characters or less.T Set the node role.Press "N." The command prompt changes to "Enter RRP Node Type (M/T) >." Press "M" to setthe domain for a master node. Press "T" to set the domain for a transit node.P Set the primary port.Press "P." The command prompt changes to "Enter RRP Primary Port >." Enter the port num-ber you wish to set as a primary port.S Set the secondary port.Press "S." The command prompt changes to "Enter RRP Secondary Port >." Enter the portnumber you wish to set as a secondary port.O Set the polling interval.Press "O." The command prompt changes to "Enter RRP Polling Interval>." Enter a valuebetween 1 and 2 (seconds) as the polling interval.F Set the timeout for polling.Press "F." The command prompt changes to "Enter RRP Fail Period>." Enter a value between2 and 5 (seconds) as the timeout for polling.S Set the control VLAN ID.Press "S." The command prompt changes to "Enter Control VLAN ID >." Enter the VLAN ID (2to 4094) you wish to set as a control VLAN. When entering two or more port numbers, sep-arate them with a comma without a space, or use a hyphen for consecutive numbers.D Set the data VLAN ID.The command prompt changes to "Enter Data VLAN ID >." Enter the VLAN ID (1 to 4094)you wish to set as a data VLAN. When entering two or more VLAN IDs, separate them witha comma without a space, or use a hyphen for consecutive numbers.A Set a domain.Press "A" to apply your settings.Q Return to the parent menu.Note: If you press "Q" (Quit) after setting a domain, your settings will not be applied.Be sure to press "A" (Apply) to apply your domain settings.
