134Available commands are listed below.S Set whether the power supply is enabled or disabled.1. Press "S." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Up or Down PoE port admin status (U/D)>."Press "U" to enable power supply (Up). Press "D" to disable it (Down).I Set the priority for power supply.1. Press "I." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enter the selection>." Press "1" for Critical, "2"for High, or "3" for Low.L Set the upper limit of power supply.1. Press "L." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enter limit mode for port # (A/M)>." Press "A"to set the upper limit automatically or "M" to set it manually.3. If "M" is selected, the command prompt changes to "Enter the power limit>." Enter thelimit between 3000 and 30000 mW (in units of 200 mW).As the change is applied, the display on the upper screen is updated automatically.If the upper limit of power supply amount is set to Auto, the following values are set auto-matically as limiting values of the port with combination of Layer and Class after the termi-nal device is detected.If the upper limit of the power supply is set to Auto, the limiting value of the port is auto-matically set with the Class value after the power supply terminal is detected.Class Layer1 20 15400 140001 4000 40002 7000 68003 15400 140004 15400 30000L Set the upper limit of power supply.1. Press "L." The command prompt changes to "Select port number to be changed>." Entera port number you wish to configure. (To configure all ports at once, enter "0" as theport number.)2. Then, the command prompt changes to "Enter the power limit>." Enter the limitbetween 3000 and 15400 mW (in units of 200 mW).Q Return to the parent menu.Note: To supply power to a IEEE802.3at non-compatible PoE power receiving devicethat requires power of 15.4 W or more and does not support 2-Event PhysicalLayer Classification or Data Link Layer Classification, the upper limit of powersupply should be set manually between 15600 to 30000 mW.Note: If power request exceeds the limit of the whole unit, a port with a larger portnumber is blocked to stop supplying power.
