123Available commands are listed below.P Set the port number.Press "P." The command prompt changes to "Enter port number>." Enter the port numberyou wish to configure.C Set the operation mode for authentication requests.Press "C." The command prompt changes to "Select authenticator port control (A/U/F) >."Press "A" to enable the authentication function. Press "U" to disable it and block communi-cations. Press "F" to disable it and authorize communications.T Set the interval time for authentication requests.Press "T." The command prompt changes to "Enter Transmission Period>." Enter an integerbetween 1 and 65535 (seconds).L Set the timeout for the supplicant.Press "L." The command prompt changes to "Enter Supplicant Timeout value>." Enter aninteger between 1 and 65535 (seconds).O Set the timeout for the authentication server.Press "O." The command prompt changes to "Enter Server Timeout>." Enter an integerbetween 1 and 65535 (seconds).M Set the maximum number of reattempts of authentication.Press "M." The command prompt changes to "Enter Max request count>." Enter the maxi-mum number of reattempts with an integer between 1 and 10.U Set the period time to wait before reattempting a failed authentication.Press "U." The command prompt changes to "Enter Quiet Period>." Enter an integerbetween 1 and 65535 (seconds).X Set the maximum number of reattempts of authentication.Press "X" The command prompt changes to "Enter Max request count>." Enter the maxi-mum number of reattempts with an integer between 1 and 10.E Set the re-authentication time interval.Press "E." The command prompt changes to "Enter re-authentication Period>." Enter an inte-ger between 1 and 65535 (seconds).A Enable/disable re-authentication.Press "A." The command prompt changes to "Enable or Disable re-authentication ?(E/L/D)>." Press "E" to enable the authentication using the Re-authentication timer value on theRADIUS server. Press "L" to enable the authentication using the Re-authentication timervalue on this Switching Hub. Press "D" to disable it.I Initialize the authentication status.Press "I." The command prompt changes to "Would you initialize authenticator?(Y/N)>." Toinitialize it, press "Y." Otherwise, press "N."R Initialize the re-authentication status.Press "R." The command prompt changes to "Would you want to initialize re-authentica-tion?(Y/N) >." To initialize it, press "Y." Otherwise, press "N."Q Return to the parent menu.
